CROWN - CTD-8125 - CT 8X125W DANTE AMP EK VER

Dante Inputs and Outputs
DSP for Room Tuning and Speaker Tuning
Power Sharing
WebUI Configuration
Lo-Z/Hi-Z switchable outputs
Compact Design
Factory JBL SpeakerTunings
Pilot Tone & Load Monitoring
Source Priority Switching
GPIO Interface
Hcontrol. Performance
Crosstalk 20 Hz to 1 kHz: <-90dB
Common Mode Rejection (20 Hz to 1 kHz): > 55 dB
Damping Factor (20Hz to 100Hz): ³100
Digital Signal Processing: 48kHz
Frequency response @ 4/8 ohm: 20 Hz - 20 kHz +/- 0.5 dB
Intermodulation Distortion (60Hz and 7kHz AT 4:1, From - 30dB To Full Rated Power): ²0.35%
Input Impedance: 20k, balanced
Input Sensitivity @ 8 ohm: 1.58Vrms (4 & 8ch)
Maximum Fan Noise (Red. dB SPL @ 1M): 48dB
Maximum Input Level: +20dBu
Signal to Noise Ratio (below rated power 20 Hz to 20 kHz, A-Weighted): 104dB Analogue, 113dB Dante
THD+N at 4/8 ½, 70V/100V, @1dB below rated power: ²0.1%
Voltage Gain (8½, 1kHZ, Vin = 100mV): 32dB
100V Output Voltage (loaded to 250W/500W): 93Vrms
Connectors
Analogue Audio Input: 3.5mm Phoenix Terminal Block connector
Digital Audio Input/Output (Dante/AES67): 2x RJ45
Speaker Output: 5.08mm Phoenix Terminal Block connector
GPI: 8in, 2x 6pin 3.5mm Phoenix Terminal Block Connector
Fault Relay Output: NO, COM, NC
Power: Standard IEC
Power
Power (1kHz, 20ms burst, all channels driven, 0.1% THD)
Rated Power (8½): 125W x 8
Rated Power (4½): 125W x 8
Rated Power (70V/100V): 125W x 8
Power (1kHz, 20ms burst, single channel driven, 0.1% THD)
Rated Power (8½): 500W x 2
Rated Power (4½): 500W x 2
Rated Power (70V/100V): 500W x 2
Electrical
Power Supply: Universal power supply, voltage:100-240VAC, 50/60Hz
Power Saving:
Standby Consumption
GPI Standby <0.5W
Auto Standby with Network Control <2W
Wakeup Time from Sleep: <250ms